Toa SP-1100 - Manual

4. SPECIFICATIONS
3. NOMENCLATURE AND DIMENSIONAL DIAGRAM
INSTRUCTION MANUAL
WALL MOUNTING BRACKET
SP-1100
Thank you for purchasing TOA's Wall Mounting Bracket.
Please carefully follow the instructions in this manual to
ensure long, trouble-free use of your equipment.
420
333
33
126 156
282
77
Dustproof cover
Stay
Slotted hole
Holder
[Front] [Side]
[Megaphone mounted view]
SP-1100
Megaphone
Unit: mm
Wall
Note: The design and specifications are subject to
change without notice for improvement.
• Accessories
4 x 16 tapping screws ................................ 2
• Before installation or use, be sure to carefully read all
the instructions in this section for correct and safe
operation.
• Be sure to follow all the precautionary instructions in
this section, which contain important warnings and/or
cautions regarding safety.
• After reading, keep this manual handy for future
reference.
1. SAFETY PRECAUTIONS
WARNING
Indicates a potentially hazardous situation which,
if mishandled, could result in death or serious
personal injury.
• Install the unit only in a location that can structurally
support the weight of the unit and the mounting bracket.
Doing otherwise may result in the unit falling down and
causing personal injury and/or property damage.
• Avoid mounting the bracket in locations where people
could accidentally bump into it. Failure to observe this
could result in personal injury.
CAUTION
Indicates a potentially hazardous situation which,
if mishandled, could result in moderate or minor
personal injury, and/or property damage.
• Since the unit is designed for indoor use, do not install it
outdoors. If installed outdoors, the aging of parts
causes the unit to fall off, resulting in personal injury.
Also, when it gets wet with rain, there is a danger of
electric shock.
• Use the specified megaphone in combination. Doing
otherwise may cause the unit or component to fall off,
resulting in personal injury.
• Do not stand or sit on, nor hang down from the unit as
this may cause it to fall down or drop, resulting in
personal injury and/or property damage.
2. GENERAL DESCRIPTION
The SP-1100 bracket is designed to be used exclusively
to mount the ER-1203 and ER-1206 series megaphones
on a wall. It permits the megaphone to be installed in
easy-to-see locations, and the megaphone can be easily
mounted and detached. The dustproof cover protects the
megaphone's mouthpiece while the megaphone is placed
in the bracket, offering improved hygienic safety.
Finish Stay: Stainless steel (SUS304)
Holder, dustproof cover: ASA resin,
dark gray clear
Dimensions [With dustproof cover and holder open]
126 (w) x 420 (h) x 156 (d) mm
Weight 410 g
Usable ER-1203,
Megaphone
ER-1206, ER-1206S, ER-1206W