Toa NX-100S Manual - Manual (Page 5)

5
(2) Press the Start button.
Connection to the pressed Selection button's programmed NX-100 and NX-100S units begins.
If all units are connected, the indication "Connection succeed to all designated units.*" is displayed in
the message display area, and the corresponding Selection button changes color to orange.
* When only a portion of the programmed units is connected, the indication "Connection failure to
some designed units." is displayed.
NX-100 and NX-100S units that are not connected are displayed in the message display area.
Depending on the displayed messages, perform operation again after temporarily terminating the
program and waiting a short time, or after correcting any setting- or unit-related problems. The
Selection buttons change to orange if a connection is made to at least one of the NX-100 or NX-100S
units programmed for that button.
2-1. When Start button is displayed;
(1) Press either the Selection or Group button to select broadcast locations.
Multiple locations can be simultaneously selected. Selected buttons are highlighted in white. When
the Group button is pressed, all the Selection buttons programmed into the Group button are also
highlighted in white.