Creda R010E - Manual (Page 28)

4. CONTROL PANEL / TRIMS / INNER DOOR PANEL & GLASS
(a) Control Panel
Regularly wipe with a clean, damp cloth and polish with a
clean, dry cloth.
(b) Trims
It is advisable to clean the trims regularly to prevent any
build up of soiling which may detract from the
appearance of the cooker. The recommended method of
cleaning is to wipe over the trims with a clean, soft cloth
wrung out in hot water, or mild non abrasive cleaner. (If in
doubt try the cleaner on a small area of trim which is not
noticeable in normal use), then after wiping with a cloth
wrung out in clear water, dry with a clean, soft cloth.
(c) Inner Door Panels & Glass
Open the door fully. The glass panel may now be washed.
Stubborn stains can be removed by using a well soaped,
fine steel wool soap pad.
5. REPLACEMENT OF THE OVEN LAMP
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove the lens.
Carefully unscrew the bulb anti-clockwise. Fit replacement
bulb (15W 300°C SES). Fit replacement bulb and refit lens.
6. HOW TO CLEAN THE LAMP LENS
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove. Clean with a non-abrasive
cleansing cream and refit lamp lens.
Care and Cleaning
DO NOT use scouring pads, or abrasive powder, which
will scratch the glass.
Warning: Before removing lamp lens, please ensure that
the electricity supply to the appliance is switched off
and the appliance is fully cold.
Warning: Before cleaning lamp lens, please ensure that
the electricity supply to the appliance is switched off
and the appliance is fully cold.
DO NOT use scouring pads, or abrasive powder, which
will scratch the glass lens
TRIMS
OVEN
DOOR
MAIN OVEN LAMP
28
MAIN OVEN LAMP