Toa F-2352SC - Manual (Page 6)

6
Step 4. Mount the speaker.
Caution
Before mounting, check to be sure that the speaker's
3 mounting tabs are turned inside the unit as shown in
the figure.
If turned outward, the speaker cannot be inserted
through the mounting hole.
In
Out
Mounting tab
9 mm (23/64")
Step 3. Connect the speaker cable to the push-in terminal.
Tip
Use the 600 V vinyl-insulated cable (IV or HIV wire).
The following matching cable types are recommended:
• Solid copper wire: ш0.8 – ш1.6 mm (equivalent to AWG 20 – 15)
• Stranded copper wire: 0.75 – 1.25 mm 2 (equivalent to AWG 18 – 17)
Press fully down on the corresponding terminal button and
insert the cable.
Tip
To detach the cable, press fully down on the terminal button
again, then pull the cable.
[If bridging] [If not bridging]
To the next speaker
From Amplifier
2-5. Hanging from a ceiling suspension pipe (exposed installation)
Use the optional HY-BC1 Back Can.
Note
Refer to the instruction manual included
with the HY-BC1 for Back Can installation.
Suspension pipe
Speaker cable
HY-BC1 (optional)
Caution
Ensure that this length is
shorter than 53 mm (2
3 / 32 ").
[Installed HY-BC1]
(Example of mounting to suspension pipe)