Toa HY-CN7W-WP - Manual (Page 5)

5
3
-1
3
-1
Flange nut (for M6, accessory)
Rear bracket of speaker module B
Rear bracket of speaker module A
Speacer (black, accessory)
Rear angle bar of this bracket
Hex head bolt M6 x 25
(with spring and plain washers, accessory)
Tightening torque: 3 N·m
Hex head bolt M6 x 25
(with spring and plain washers, accessory)
Tightening torque: 3 N·m
Fulcrum for the angle adjustment
Rear angle bar of this bracket
Angle adjustment holes
0° mode
15° mode 30° mode
45° mode
[Completed installation (0° mode)]
3-1. Attach the HY-CN7 bracket's rear angle bar to the rear bracket of speaker module A.
Use the supplied hex head bolts and nuts.
Fit the spacer (black) into the larger hole in the rear angle bar, then with the angle bar positioned
between the two plates of rear bracket A, and with holes aligned, insert the bolt through the rightmost
hole in the rear bracket, and fasten with the nut.
Notes
• This position will act as the fulcrum for angle adjustment. Be sure that the angle bar is fixed in the
position indicated in the illustration below. If fixed in a different position, the angle mode will not
conform with the specified value.
• Be sure a spacer (black) is fitted into the larger hole in the rear angle bar.
3-2. Attach the HY-CN7 Series bracket's rear angle bar to the rear bracket of speaker module B.
Use the supplied hex head bolt and nut.
Align the rear angle bar with the desired directivity angle mode position, then insert a bolt and fasten
with a nut.
The figure shows a mounting example with 0° mode selected.
Notes
• A spacer is not used.
• When a 60° mode is desired, use the optional HY-60D Series Speaker Angle Adjustment Brackets.
For details, refer to the installation manual enclosed with the HY-60D Series brackets.