Toa HY-TM7W-WP - Manual (Page 2)

2. GENERAL DESCRIPTION
The HY-TM7 Series Speaker Rigging Brackets are used to hang the HX-7B-WP or HX-7W-WP Speaker System
directly from ceilings, beams or other building structures, including under outdoor eaves.
3. NOTES ON INSTALLATION
• Observe the following instructions when installing the speaker
system.
Failure to do so could adversely affect their intended weather-
resistant capability, leading to malfunction.
· Install the speaker system in locations not exposed directly to
rain, such as under eaves.
· All speaker modules must point downward from the horizontal.
• Two joined HX-7 Series Speaker Systems cannot be installed
with this bracket.
4. INSTALLATION
Step 1. Mount this bracket to a ceiling, beam, etc. using the bolts.
Bolts and nuts for mounting the bracket on the ceiling or beam are not
supplied.
Use bolts and nuts that are appropriate for the ceiling’s or beam’s
structure and composition. Failure to do so may cause the speaker to
fall, resulting in material damage and possible personal injury.
WARNING
[Mounting dimensions]
36
(1.42")
146.5 (5.77")
[Front] [Right side]
ø8.5 (0.33") (with M8 weld nut)
ø8.5 (0.33")
(with M8 weld nut)
ø8.5 (0.33")
(with M8 weld nut)
ø8.5(0.33")
(6 positions)*
353 (13.9")
60 (2.36")
100 (3.94")
100 (3.94")
0
26
(1.02")
76
(2.99")
126
(4.96")
291
(11.46")
220
(8.66")
170
(6.69")
φ8.5 (0.33")*
Note: Left-side surface same.
Unit: mm
*These holes not fitted with M8 weld nuts.
[Vertical installation]
Horizontal