Toa SR-PB5 - Manual (Page 12)

12
8. BEFORE INSTALLING THE SPEAKER
Anchor bolts must first be installed when mounting the SR-T5 line array speaker on a wall.
8.1. Anchor Bolt Mounting Dimensions
8.2. Speaker Cable Outlet Position When Installing the SR-T5 Flat against Wall
M10 Safety Wire Anchor Bolt
When using the supplied mounting bracket or the optional SR-PB5 Wall Pan
Bracket, the location of the anchor bolt is as follows:
When installing the speaker on the right-hand side* 1 of the stage
as viewed toward the stage.
Mount (A):
When using SR-PB5, the speaker can be turned left as viewed toward the
stage. * 1
When using SR-PB5, the speaker can be turned right as viewed toward
the stage. * 2
When installing the speaker on the left-hand side* 2 of the stage
as viewed toward the stage.
Mount (B):
M10 Bracket Anchor Bolt
Be sure that the following bolt lengths
project from the wall surface:
Mount the supplied mounting bracket A
or optional Pan Bracket A.
Mount the supplied mounting bracket B
or optional Pan Bracket A.
Unit: mm (inches)
213 ±2
(8.39 ± 0.08)
50 ±2 (1.97 ± 0.08)
300 ± 5 (11.81 ± 0.2)
50 ± 2
(1.97 ± 0.08)
850 ±3 (33.46 ± 0.12)
(A) (B)
[In the case of a single nut]
[In the case of a double nut]
18 – 30
(0.72 – 1.18)
25 – 30
(0.98 – 1.18)
Wall
Wall
Unit: mm (inches)
The 15 mm (0.59") – high ridges in the back of the
speaker provide ample space for speaker wiring.
Even when the speaker is mounted flat against wall,
the speaker cable outlet hole in the wall does not
need to be aligned with the cable entry hole position.
Mounting Bracket B
(accessory)
Speaker cable
outlet position
Unit: mm (inches)
Speaker
Wall
[Viewed from the upper side]
Mounting Bracket A
(accessory)
15 (0.59)
200
(7.87)
200
(7.87)
50
(1.97)
50
(1.97)
170
(6.69)
380 (14.96)
Note