Toa DH-120 - Manual

DH-110
DH-120 STRAIGHT HORN SPEAKER
INSTRUCTION MANUAL
Indicates a potentially hazardous situation which, if mishandled, could result in death or
serious personal injury.
WARNING
• The standard supplied mounting bracket is not designed for use in locations exposed to strong winds and could become
dislodged, resulting in possible personal injury. To ensure that the installation can withstand expected wind forces,
always use the supplied mounting bracket in combination with a separately prepared bracket.
• Install the unit only in a location that can structurally support the weight of the unit and the mounting bracket. Doing
otherwise may result in the unit falling down and causing personal injury and/or property damage.
• Use nuts and bolts that are appropriate for the ceiling's or wall's structure and composition. Failure to do so may cause
the speaker to fall, resulting in material damage and possible personal injury.
• Tighten each nut and bolt securely. Ensure that the bracket has no loose joints after installation to prevent accidents that
could result in personal injury.
• Attach the safety wire to the unit when mounting in locations high above the ground. Failure to do so could result in
personal injury if the speaker should later fall for any reason.
• Protect the unit from exposure in snowy areas, as the weight of snow build-up could cause the speaker to fall, resulting
in personal injury.
1. SAFETY PRECAUTIONS
• Be sure to read the instructions in this section carefully before use.
• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as
very important precautions are included.
• We also recommend you keep this instruction manual handy for future reference.
2. EQUIPMENT CONFIGURATION
The DH-110 speaker is comprised of the DHA-11 (Horn A) and the DH-11B component (Horn B, Horn C and other parts).
The DH-120 speaker is comprised of the DHA-11 and the DH-12B component (Horn B, 2-driver unit adapter and other parts).
3. USABLE DRIVER UNITS
Any TOA driver unit can be used. However, an optional thread adapter is required when using the driver unit TU-50S or
TU-50L (both old models). Refer to the section "Installation Precautions."
4. SPECIFICATIONS (common to the DH-110 and DH-120)
Horn A
Horn B
2-driver unit adapter
Horn C
Mounting bracket
Bird net
Rubber gasket A
Throat net
Rubber gasket B
Hex bolt (M12), plain washer (M12), spring washer (M12)
M6 hex bolt with spring washer, M6 washer
M4 screw 1 -
- 1
- - 1
- 1 -
- 1
- 1
- 1
- 1
- 1
- 6 each (stainless steel)
- 8 each (stainless steel)
- 2* (stainless steel)
* Although two screws are supplied, only one screw is used to assemble the DH-110.
Parts to make up
the component
Component Model No. DHA-11 DH-11B DH-12B
DH-110
DH-120
Speaker Model No.
110 dB (1 W, 1 m) (when TU-630 or TU-650 series is used)
180 – 6,000 Hz (when TU-630 or TU-650 series is used)
+10° or –20° (when using separately-prepared mounting bracket of the type that permits
changes of speaker mounting angles)
Inch-threaded screws
Ivory
5.3 kg (speaker only)
Output Sound Pressure Level
Frequency Response
Variable Vertical Mounting Angle
Driver Unit Coupling Screws
Color
Weight
Note: The design and specifications are subject to change without notice for improvement.