Toa PC-2268WP - Manual (Page 7)

7
2-2. When installing the speaker mounting panel to an exposed electrical box (Refer to the figure below.);
Caulking treatment
2
-2
1
-2
Note
Be sure to waterproof the joint of the cable conduit
and electrical box.
Caulking compound
Exposed electrical box
Exposed electrical box Cable conduit
Cable entry hole
Speaker mounting panel
(accessory)
Mounting screw
Speaker mounting panel dimensional diagram
Unit: mm
5 x 15
5 x 13.4
5 x 10
Speaker cables (input line and bridge line)
Note
Mounting dimension of the Speaker mounting panel is
66.7 - 83.5 mm.
Prepare an electrical box that matches this range.
ø22
66.7
83.5
Note
When routing the speaker cables, do not pull them out more than 30 cm.
If pulled out more than that, the speaker cables may not be housed inside the case.