Toa CMB-31 - Manual (Page 2)

WCB-31 WCB-31W CMB-31 CMB-31W
F-240 series speaker systems
8 kg or less
Black White Black White
0.9 kg 0.7 kg
Speaker mounting screw x 2
Hexagon wrench (large/small) x 1 each
Instruction manual x 1
1. Disassemble the mounting bracket into the suspension bracket and bracket base.
• Pull out the safety pin, and remove the vertical angle adjustment screw using the
supplied hexagon wrench (large).
2. Mount the suspension bracket to a speaker
using the supplied two speaker mounting
screws (M5). Refer to the right figure.
3. Mount the bracket base to a wall or ceiling.
Verify that the wall or ceiling can safely support
the weight of both the speaker mounting bracket
and mounted speaker, and reinforce if its
strength is insufficient.
Note
No screws are supplied for mounting the bracket base to a wall or ceiling.
Prepare the commercial screws appropriate for the wall or ceiling material.
4. Fix the suspension bracket mounted on the speaker to the bracket base.
• Tighten the vertical angle adjustment screw securely with the supplied hexagon wrench
(large), and insert the safety pin.
5. Determine and fix the speaker direction.
• Tighten the vertical and horizontal angle adjustment screws securely with the supplied
hexagon wrenches (large/small).
4.2 Dimensions of the Bracket Base (Unit: mm)
64
65
65
Mounting hole
(6 places)
76
76
Speaker cable hole
(2 places)
Speaker cable hole (2 places)
5
5
Mounting hole
(4 places)
4. INSTALLATION
4.1 Procedures
Suspension
bracket
Speaker
Speaker mounting screw
• CMB-31/CMB-31W • WCB-31/WCB-31W
Model
Applicable speaker
Load limit of speaker
Finish (painting)
Weight
Accessories
4.3 Mounting Examples of the F-240 Series Speaker Systems
• When mounting the speaker to a wall using the WCB-31 or WCB-31W
30 to 60
degrees
• When mounting the speaker to a ceiling using the CMB-31 or CMB-31W
Note
When mounting the speaker to
vertical direction, be sure to set
the speaker mounting angle to
downwards within an angle of
30 to 60 degrees.
30 to 60
degrees
Note
When mounting the speaker to
vertical direction, be sure to set
the speaker mounting angle to
downwards within an angle of
30 to 60 degrees.
5. SPECIFICATIONS
Note: Specifications are subject to change without notice.
Caution: Verify that both bracket contacts are securely fitted each other.