Crate Amplifiers V18-112 - Manual (Page 5)

V18-112/V18-212 Tube Guitar Amplifier with Reverb
5
The Rear Panel
11. AC LINE CORD: The grounded power
cord should only be plugged into a
grounded power outlet that meets
all applicable electrical codes, and is
compatible with the voltage, power, and
frequency requirements stated on the
V50-112 rear panel. Do not attempt to
defeat the safety ground connection.
12. Voltage Select Switch: Set this switch
to “115” for 120 VAC mains, and to
“230” for 220-240 VAC mains.
With the amplifier power cord
unplugged, use the tip of a small flat-
blade screwdriver to slide this switch to
the proper position.
13. REVERB IN Jack: The V18 is shipped
with a cable connected from this jack to
the input of the internal spring reverb.
14. REVERB OUT Jack: The V18 is
shipped with a cable connected from
this jack to the output of the internal
spring reverb.
15. LINE OUT: Use this 1/4" TS jack to
send the signal from the preamplifier
stage of the V18 to a mixer or recorder.
The signal comes after the EQ stage
but before the reverb stage.
16. SPEAKER 8 OHMS: The V18 is
shipped with a cable connected from
this jack to the internal speaker(s).
V18-112: One 8-ohm speaker
V18-212: Two 16-ohm speakers in
parallel = 8 ohm load
SERIAL NUMBER
MANUFACTURING DATE
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
US C
3031613 CONFORMS TO IEC 60065
~120-240VAC 50-60 Hz N222
AVIS: RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER. NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
115
c 2007 LOUD TECHNOLOGIES INC
DESIGNED IN ST.LOUIS MO, USA . MANUFACTURED IN CHINA, FABRIQUE EN CHINE
REVERB
IN OUT
SPEAKER LINE OUT
8Ohms
13
11 12
14 15 16