Toa C-BC850W - Manual (Page 4)

4
46
83.5
Camera mounting screw
M4 x 12 (Accessory)
Wall mounting screw
M4 or M5
Cover
Wall mounting
bracket
Safety wire
fixing hole
Base mounting screw
M4 x 16 (Accessory)
Joint base (Accessory)
Plain washer
Spring washer
Grommet
4.2. Installation
1. Loosen 3 cover fixing screws to remove the wall mounting bracket. (The cover is connected to the wall
mounting bracket using the safety wire.)
2. Attach the wall mounting bracket to a wall using 4 wall mounting screws (M4 or M5) referring to the figure
below.
Notes
• Since no mounting screws are supplied with the bracket, separately prepare screws that are appropriate
for the construction of wall.
• In the case of exposed wiring, cut a hole in the grommet attached to the wall mounting bracket, then route
the cable in the bracket through this hole.