Toa C-CV854D-3 CE - Manual (Page 13)

13
Mode Setting Switch
(Factory-preset setting)
1 : Focus adjustment switch
2 : Backlight compensation switch
3 : Flickerless switch
4 : ATW/AWB selection switch
5 : Mode selection switch ON OFF
1
2
3
4
5
FOCUS ADJUST
BLC
SHUTTER
ATW
D / N
AWB
COLOR
ON OFF
1
2
3
4
5
ON OFF
1
2
3
4
5
ON OFF
1
2
3
4
5
ON OFF
1
2
3
4
5
ON OFF
1
2
3
4
5
ON OFF
1
2
3
4
5
8. ABOUT THE MODE SETTING SWITCH
Set each switch to the position that provides the best picture reproduction.
8.1. Focus adjustment switch
Set this switch when adjusting the lens focus. (This setting provides the same effect as when using an ND filter.)
Standard position :
Set to OFF after lens adjustment completion. Set to this position during normal use.
Focus adjustment position (during adjustment) :
Use this position when focusing the lens. If the focus is adjusted for a subject under
good lighting conditions, the subject may go out of focus when conditions become
dark. Set the Focus adjustment switch to ON only when performing focus adjustment.
Note: When the Focus adjustment switch is set to the "ON" position, the color of the screen
may change periodically if the camera is used under fluorescent lighting. Further, the
screen may flicker in areas where the electrical frequency is 50 Hz (CU) or 60 Hz (CE).
8.2. Backlight compensation switch
Set this switch so that the subject is not displayed in black when backlit.
Standard position :
Set to this position during normal use. Backlight compensation function does not
operate when the switch is set to this position.
Backlight Compensation position (when backlit) :
This position compensates images from being displayed in black when the image is
backlit.
8.3. Flickerless switch
Set this switch to the ON position when annoying screen image flicker is detected.
Standard position :
Set to this position during normal use.
Flickerless :
Annoying screen flicker may result under fluorescent lighting in areas operating with a
power frequency of 50 Hz (CU) or 60 Hz (CE). In such cases, set the Flickerless
switch to the ON position to permit a flicker-free picture to be viewed.
Note: If the Flickerless switch is set to the ON position, sensitivity is reduced compared to
operation in the OFF position. When using the camera in a dark location, or where
light flicker is not an annoyance, set the switch to the OFF position.