Toa C-RM1000 HV - Manual (Page 41)

41
G R O U P
2 . T R A N S F E R 2
T R A N S F E R
1 . R M R F
1
When selecting “Transfer”…
1. Select [GROUP] while the menu is displayed and press the SET key.
The setting content is displayed on the second line.
2. Select [2. TRANSFER] and press the SET key.
3. Select EITHER [RM RF] or [RM RF] and press the SET key.
The “TRANSFERRING...” indication is displayed while data is being
transferred, and the “TRANSFER COMPLET” indication is displayed
when the transfer is completed.
[RM
RF] : Transmits data to the interface unit.
[RM RF] : Receives data from the interface unit.
When selecting “Erase”…
1. Select [GROUP] while the menu is displayed and press the SET key.
The setting content is displayed on the second line.
2. Select [ERASE] and press the SET key.
3. Select [YES] or [NO] and press the SET key.
[YES] : Deletes the setting and resets to default conditions.
[NO] : Does not delete the setting.
Note
Default settings: Group: 1, DVR: 1 - 8, Control: ON, Number of the Channels: 16
G R O U P
3 . E R A S E 3
Note
Abbreviation settings programmed into a single Remote Controller can be easily transferred to multiple
Remote Controllers.
Follow the procedures below to perform settings.
1. Set monitor lock for the Remote Controller.(Refer to p. 50 ; Monitor Lock)
When restricting monitors to be operated by the Remote Controller, set Monitor Lock for each Remote
Controller. If an abbreviation (quick display function)-set monitor is locked, camera images are quickly
displayed on an unlocked Monitor instead when the abbreviation-set monitor is called. So, you do not need
to change the abbreviation (quick display function) -set monitor number.
2. Program the abbreviation number setting into one Remote Controller.
(Refer to p. 42 ; Abbreviation, "Quick Display function."), (Refer to p. 43 ; Abbreviation (Function
programming).
3. Transfer the abbreviation number settings to each Remote Controller.
(Refer to p. 41 ; When selecting "Transfer"...)
[ Setting contents ]
1. Setting
Programs the abbreviation numbers into the Remote Controller. The following two
functions can be assigned to abbreviation settings: Quick display function and
Function programming.
2. Transfer
Transfers Abbreviation settings to other Remote Controllers via the C-RF1000
Interface unit. Transfer method is the same as that of group settings.
3. Erase
Erases all abbreviation settings. Function programming settings return to the
default setting.
12.4.2. Abbreviation