Top Flite TOPA0951 - Manual (Page 8)

8
❏
5. Glue the belly pan into position with 30-minute
epoxy—use care not to allow excess epoxy to
inadvertently glue the wing or belly pan to the fuselage.
❏
6. With the wing mounted to the fuselage, hold the
left wing air intake up against the fuselage. Use a
fi ne-point felt-tip pen to mark where to trim the intake
for a perfect fi t.
❏
7. Trim and fi t the intake as necessary until it fi ts well.
❏
8. Holding the intake in position, use a fi ne-point
felt-tip pen to mark its outline onto the top and bottom
of the wing.
❏
9. Use a small pin to perforate the covering just
inside the outlines.
❏
10. Use one of your paper towel squares and
denatured alcohol to wipe the ink lines from the wing.
Hold the intake into position and carefully glue it to
the wing with thin CA. Or, use J&Z R/C 56 canopy
glue instead. If using canopy glue, hold the intake to
the wing with masking tape until the glue dries.
Hint:
If using CA, fi rst use CA accelerator to lightly “prime”
the underside of the intake where it contacts the wing.
Allow the accelerator to dry for a few seconds, then
glue in place.
❏
11. Trim, fi t and glue the right intake into position
the same way.