Top Flite TOPA0708 - Manual (Page 30)

30
GENERAL
1) I will not fl y my model aircraft in sanctioned events,
air shows, or model fl ying demonstrations until it has
been proven to be airworthy by having been previously,
successfully fl ight tested.
2) I will not fl y my model aircraft higher than approximately
400 feet within 3 miles of an airport without notifying the
airport operator. I will give right-of-way and avoid fl ying
in the proximity of full-scale aircraft. Where necessary,
an observer shall be utilized to supervise fl ying to avoid
having models fl y in the proximity of full-scale aircraft.
3) Where established, I will abide by the safety rules for
the fl ying site I use, and I will not willfully and deliberately
fl y my models in a careless, reckless and/or dangerous
manner.
5) I will not fl y my model unless it is identifi ed with my
name and address or AMA number, on or in the model.
Note: This does not apply to models while being fl own
indoors.
7) I will not operate models with pyrotechnics (any device
that explodes, burns, or propels a projectile of any kind).
RADIO CONTROL
1) I will have completed a successful radio equipment
ground check before the fi rst fl ight of a new or repaired
model.
2) I will not fl y my model aircraft in the presence of
spectators until I become a qualifi ed fl ier, unless assisted
by an experienced helper.
3) At all fl ying sites a straight or curved line(s) must be
established in front of which all fl ying takes place with
the other side for spectators. Only personnel involved
with fl ying the aircraft are allowed at or in the front of
the fl ight line. Intentional fl ying behind the fl ight line is
prohibited.
4) I will operate my model using only radio control
frequencies currently allowed by the Federal
Communications Commission.
5) I will not knowingly operate my model within
three miles of any pre-existing fl ying site except in
accordance with the frequency sharing agreement
listed [in the complete AMA Safety Code].
9) Under no circumstances may a pilot or other person
touch a powered model in fl ight; nor should any part of
the model other than the landing gear, intentionally
touch the ground, except while landing.
Since the Giant Spitfi re ARF qualifi es as a “giant
scale’ model and is therefore eligible to fl y in IMAA
events, we’ve printed excerpts from the IMAA Safety
Code which follows.
IMAA SAFETY CODE (excerpts)
Defi nition: For the purpose of the following IMAA
Safety Code, the term Giant Scale shall refer to radio
controlled model aircraft, either scale or non-scale, which
have a wingspan of 80 inches [2032mm] or more for
monoplanes and 60 inches [1524mm] or more for multi-
winged model aircraft and have a ramp weight (fueled
and ready to fl y) of 55lbs. [24.75kg.] or less.
Section 1.0: Safety Standard
1.1 Adherence to Code: This safety code is to be strictly
followed.
1.2 The most current AMA Safety Code in effect is to
be observed. However, the competition sections of the
code may be disregarded.
Section 3.0 Safety Check
3.4 Flight Testing: All Giant Scale R/C aircraft are to have
been fl ight tested and fl ight trimmed with a minimum of
six fl ights before the model is allowed to fl y at an IMAA
Sanctioned event.
3.5 Proof of Flight: The completing and signing of the
Declaration section of the Safety Inspection form by
the pilot (or owner) shall document as fact that each
aircraft has been successfully fl ight-tested and proven
airworthy prior to an IMAA event.
Section 5.0: Emergency Engine Shut Off (Kill Switch)
5.1 All magneto spark ignition engines must have a coil
grounding switch on the aircraft to stop the engine. This
will also prevent accidental starting of the engine. This
switch shall be readily available to both pilot and helper.
This switch is to be operated manually and without the
use of the radio system.
5.2 Engine with battery power ignition systems must
have a switch to turn off the power from the battery
pack to disable the engine from fi ring. This will also
prevent accidental starting of the engine. This switch
shall be readily available to both pilot and helper. This
switch shall be operated manually and without the use
of the radio system.
5.3 There must also be a means to stop the engine
from the transmitter. The most common method is to
close the carburetor throat completely using throttle
trim. However, other methods are acceptable. This
requirement applies to all glow/gas ignition engines
regardless of size.
Section 6.0: Radio Requirements
6.1 All transmitters must be FCC type certifi ed.
6.2 FCC Technician or high-class license required for
6 meter band operation only.
Additional IMAA General Recommendations
The following recommendations are included in the
Safety Code not to police such items, but rather to offer
basic suggestions for enhanced safety.
Servos need to be of a rating capable to handle the
loads that the control surfaces impose upon the servos.
Standard servos are not recommended for control
surfaces. Servos should be rated heavy-duty. For fl ight-
critical control functions a minimum of 45 inch/ounces of
torque should be considered. This should be considered
a minimum for smaller aircraft and higher torque servos
are strongly encouraged for larger aircraft. The use of
one servo for each aileron and one for each elevator
half is strongly recommended. Use of dual servos is
also recommended for larger aircraft.
On-board batteries shall be 1000 mAh up to 20 lbs.,
1200 mAh to 30 lbs., 1800 mAh to 40 lbs. and 2000
mAh over 40 lbs. fl ying weight. The number and size