Radio set-up, Pre-flight, Engine safety precautions – Top Flite Sierra 40 Trainer Kit User Manual

Page 38

Advertising
background image

38

RADIO SET-UP

THREE CHANNEL AIRCRAFT

Transmitter

Stick Movement

Control Surface

Movement

Elevator moves up

Rudder moves right

Carburetor wide open

3. Make sure none of the pushrods are binding.

4. Make sure all of the screws and bolts on your

model are tight. Check to see that all of the servos

are secure and all of the servo wheels are screwed
on firmly.

PRE-FLIGHT

CHARGE THE BATTERIES

Follow the battery charging procedures in your radio
instruction manual. You should always charge your

transmitter and receiver batteries the night before
you go fly i ng, and at other times as recommended by
the radio manufacturer.

FIND A SAFE PLACE TO FLY

The best place to fly your R/C model is an AMA

(Academy of Model Aeronautics)-chartered club field.
Ask your hobby shop dealer if there is such a club in
your area and join. Club fields are set up for R/C
flying, which makes your outing safer and more
enjoyable. The AMA can also tell you the name of a
club in your area. We recommend that you join the
AMA and a local club so you can have a safe place
to fly and also have insurance to cover you in case
of a flying accident. (The AMA address is listed on
the front cover of this instruction book).

If a club and its flying site are not available, you

need to find a large, grassy area at least 6 miles away

from any other R/C radio operation, like R/C boats

and R/C cars, and away from houses, buildings and
streets. A schoolyard may look inviting, but it is too
close to people, power lines and possible radio
interference.

GROUND CHECK THE MODEL

If you are not thoroughly familiar with the opera-

tion of R/C models, ask an experienced modeler to
check to see that you have the radio installed cor-

rectly and that all the control surfaces do what they

are supposed to. The engine operation must also be
checked and the engine "broken in" on the ground by

running the engine for at least two tanks of fuel.
Follow the engine manufacturer's recommenda-

tions for break-in. Check to make sure all screws

remain tight, that the hinges are secure and that the
prop is on tight.

RANGE CHECK YOUR RADIO

Wherever you do fly, you need to check the

operation of the radio before each flight. This means
with the transmitter antenna collapsed and the re-
ceiver and transmitter on, you should be able to walk
at least 100 feet away from the model and still have
control. Have someone help you. Ask them to stand

by your model and, while you work the controls, tell
you what the various control surfaces are doing.

Repeat this test with the engine running at

various speeds with an assistant holding the model.

If the control surfaces are not acting correctly at all

times, do not fly! Find and correct the problem first.

NOTE: ATTACH A RUBBER BAND-ON WING

WITH A MINIMUM OFTEN #64 RUBBER BANDS.

ENGINE SAFETY

PRECAUTIONS

NOTE: Failure to follow these safety precau-

tions may result in severe injury to yourself and
others.

Keep all engine fuel in a safe place, away from

high heat, sparks or flames, as fuel is very flam-
mable. Do not smoke near the engine or fuel.

Remember that the engine exhaust gives off a great

deal of deadly carbon monoxide; therefore, do not

run the engine in a closed room or garage.

Get help from an experienced pilot when learn-

ing to operate engines.

Use safety glasses when starting or running

engines.

Advertising