Cisco 3750 - Manual (Page 31)

2-13
Catalyst 3750 Metro Switch Hardware Installation Guide
OL-9160-02
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure that the switch is attached securely to wall studs
or to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up,
as shown in
Figure 2-11 .
Warning To comply with safety regulations, mount switches on a wall with the front panel facing up.
Statement 266
Warning Suitable for mounting on or over concrete or other non-combustible surface only. Statement 345
Figure 2-11 Mounting the Switch on a Wall
After the switch is mounted on the wall, perform these tasks to complete the installation, to run the setup
program, and to access the switch:
• Connect to the console port, and start the emulation software. See the “Connecting to the Console
Port” section on page C-3 and the “Starting the Terminal-Emulation Software” section on page C-3 .
• Power on the switch. See the “Connecting to a Power Source” section on page C-4 .
1 User-supplied screws
97438
SY ST RP S MA ST R ST AT DU PL X SP EE D ST AC K MO DE
1
1