Top Flite Nobler - Manual (Page 4)

FUSELAGE
8. Pin F-ll in position on top view of fuselage. Pin both fuselage sides over
plan upside-down, and glue to F-ll. Use Tri-Aids as shown in Fig. 6 to keep
sides v e r t i c a l
9. Glue shaped tail block between sides at rear end. Glue F-6 thru F-10 in place.
10 . G l u e motor-mount sub-assembly between sides See Fig. 7. Glue 1/2" x 2-3/4
x 11-7/8" block between sides and to F-3 and F-4.
11. Glue 1/2" triangular longerons to sides and formers, cutting to scarf-
joint at rear end.
WING
12 Pin Tri-Aids to plan in pairs to support mainspars. Slip spars W-18 between
T r i - A i d s but do not pin to Tri-Aids or to plan. Glue spars together at center
joints only. See Fig. 8.
3