Radio system rules, Radio system basic adjustments, Radio system controls – Traxxas 56076-1 User Manual

Page 13

Advertising
background image

SUMMIT • 13

Spring Clip Installation
1. Insert the two tabs on

the spring clip into the
rectangular tab slots in
the chassis.

2. Rotate the spring clip

upward.

3. Snap the tabs into place.
Many LiPo batteries do not use a hard plastic case. If using LiPo
batteries that do not have a hard case, always be sure to use the foam
rubber cushion in the front of the battery compartment. Do not use
the battery retainer tabs in the front of the battery compartments
when using LiPo batteries that are not in a hard plastic case.
A hard
front impact or crash when driving can damage the LiPo batteries.

RADIO SYSTEM RULES

• Always turn your TQi transmitter on first and off last. This procedure

will help to prevent your model from receiving stray signals from
another transmitter, or other source, and running out of control. Your
model has electronic fail-safes to prevent this type of malfunction, but
the first, best defense against a runaway model is to always turn the
transmitter on first and off last.

• In order for the transmitter and receiver to bind to one another,

the receiver in the model must be turned on within 20 seconds
of turning on the transmitter. The transmitter LED will flash fast
red, indicating a failure to link. If you miss it, simply turn off the
transmitter and start over.

• Always turn on the transmitter before plugging in the battery.
• Always use new batteries for the radio system.

Weak batteries will

limit the radio signal between the receiver and the transmitter.

Loss

of the radio signal can cause you to lose control of your model.

RADIO SYSTEM BASIC ADJUSTMENTS

Throttle Neutral Adjustment
The throttle neutral adjustment is located on the
transmitter face and controls the forward/reverse
travel of the throttle trigger. Change the adjustment
by pressing the button and sliding it to the desired
position. There are two settings available:
50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel (30%).

Note: We strongly recommend to leave this control in its factory
location until you become familiar with all the adjustments and
capabilities of your model.
To change the throttle neutral adjust position,
turn the transmitter off before adjusting the neutral position. You will
need to reprogram your electronic speed control to recognize the
70/30 setting.
Turn to EVX-2 Setup Programming on page 16 for instructions.

Steering Trim
The electronic steering trim located on the
face of the transmitter adjusts the neutral
(center) point of the steering channel.

TRAXXAS TQ

i

RADIO SYSTEM

Stop immediately at the first
sign of weak batteries. Never
turn the transmitter off when
the battery pack is plugged
in. The model could run out
of control.

5

RADIO SYSTEM CONTROLS

Remember, always turn the
TQi transmitter on first and
off last to avoid damage to
your model.

Forward

Neutral

Brake/Reverse

High Gear

Unlock

Diffs

Lock

Front

Diffs

Lock

Both

Diffs

Low Gear

TURN

R

IG

H

T

T

U

R

N

LE

FT

Always turn your

transmitter on first.

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

16.8V

ESC

WATERPROOF

Turn on the model.

1

2

Plug in the battery.

3

Advertising