Cobra Electronics MR F300BT - Manual (Page 8)

11 Nothing Comes Close to a Cobra ® English 10
Common MR F300 Functions
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Caution Warning
Installation Customer
Assistance
Operating Your Handset
Operation
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Caution Warning
Installation Customer
Assistance
Operating Your Handset
Home Button
Pressing this button enables you to return the handset to Standby mode from
any other mode.
Voice Dialing / Last Number Redial
This button serves two functions:
■ To enable voice dialing.
■ To redial the last number dialed from the handset.
Voice Dialing
You can activate your cell phone's voice dialing feature from Standby mode.
To Voice Dial A Number:
1. Press and release the Voice Dialing / Last Number Redial button.
2. Say the name or phone number command following the audio prompt.
The display screen will show the progress of dialing and connecting the call.
NOTE
Your cell phone must have voice dialing enabled and voice commands
recorded to use this feature with the F300.
To Redial The Last Number Dialed:
1. Press and hold the Voice Dialing / Last Number Redial button for two seconds.
The display screen will show the progress of dialing and connecting the call.
Function Buttons
The Function buttons provide different utilities to different modes of handset
operation. In any mode, the active functions are shown directly above the buttons
on the display screen as shown in this Standby display.
In this example, pressing the second button from the
left will display the Menu.
Operation
•
Once the CobraMarine Bluetooth handset has been paired with a cell phone,
incoming calls can be answered and outgoing calls can be made.
Standby
While waiting to receive or make a call, the handset will be in Standby mode.
The upper part of the screen shows the Waiting For A Call
icon and the cell phone signal strength.
The Function buttons (from left to right) will activate display
of the Volume screen, the Menu screen, the Call Log screen
and the Phonebook screen.
The Up and Down Arrow buttons will also adjust handset
speaker volume directly while in Standby or during a call.
Incoming Call
When the active paired cell phone receives a call, the ring tone will sound and it will
be announced on the handset screen.
Ringing
The call can be answered by pressing either the Answer
Function button or the Green Phone button.
If the Ignore Function button is pressed, the call will not
be accepted, but will be recorded in the Call Log.
Answered Call
The Mute Function button will disable the microphone,
but allow you to continue to hear the calling person.
To end the call and return to Standby mode, press either
the End Function button or the Red Phone button.
Caller information like name and number of the incoming
caller will only be shown if it is available on your network
and/or device.
VOL MENU LOG CONT
PAIRED TO
XXX
Functions
CONNECTED
+1 555 566 1234
MUTE END
Answered Call Display
INCOMING CALL
+1 555 566 1234
ANSWER IGNORE
Incoming Call Display
VOL MENU LOG CONT
PAIRED TO
XXX
Standby Mode
Function Names
Function Buttons
Intro Operation Customer
Assistance Warranty
Notice
ain Icons
condary Icons
Caution Warning
Installation Customer
Assistance