Trio Avionics Wing Servo Mount Installation for RV-4 and RV-6 - Manual (Page 11)

Step 12:
Wiring the servo. The servo should be wired according to the wiring
schematic provided with the servo documentation. We recommend using a shielded, multi-
conductor (3 minimum) cable for the electrical interface between the servo and autopilot
head.
Congratulations !
You’ve just completed the installation of your Trio Servo.
Ready to install installation harnesses are available from Trio.
www.trioavionics.com
Step 13:
Refer to your owners manual for initial power up, set up, and operating
instructions. THIS IS A CRITICAL STEP IN THE SUCCESSFUL INSTALLATION AND
OPERATION OF YOUR AUTOPILOT. READ THE MANUAL!
*****************************************************************************************************
The wiring harness should be installed with the servo cable run to the outer wing bay
(just aft of the main spar) where the servo will be installed. Be sure to install conduit
and/or snap bushings to protect the cable. Make certain the cable is secure and cannot
foul the controls. Depending on your installation, it may be easier to run the cable before
installing the servo and push tube.
Servo
Cable
Secure servo cable
in a manner that will
not allow controls to
be fouled.