Tuffy Security 089 Manual - Manual

Page 1 of 3 - 3/29/2010 – Rev122006
OPERATING INSTRUCTIONS
089 COMBO LOCK MOUNTED IN LATCHRTC90CMBO
Call (970) 564-1762 for Technical Support
Instructions for changing the combination
Attention: The combination pushbutton lock is typically shipped from the factory with either no code entered yet
or “12345” and will need to be reset by the customer. Alternative pre-programmed code is ________________
1. Selecting your combination
1.1. Please look at the front of the combination lock. There are buttons numbered 1 through 0. There is also an
OPEN lever and a CLEAR button. (See Figure 1)
1.2. Select your own combination and keep the combination in a safe place.
1.3. For best results, select between four and seven numbers in your combination. Each number can only be used
one time. Do not use number combinations that can be easily guessed.
Figure 1
2. Setting your combination
WARNING: Improperly setting the combination is not covered under the warranty. Do not disassemble the
lock. Doing so voids the warranty.
2.1. Press on the CLEAR to reset the combination lock. (See Figure 1)
2.2. Looking through the slots in the latch cover on the inside of the drawer you will see ten numbered buttons with
arrows. (These are actual upside down the way the latch is installed) These numbers correspond to the
numbered button on the front of the lock. (See Figure 2 and 3)