Figure 1, Figure 2 – Tuffy Security 297 User Manual
Page 2
Page 2 of 3 – 10/23/2012 – Rev 10/23/12
INSTALLER NOTES:
***Note: The #2 Front Panel is designed to fit snugly between the carpeted #5.1 cargo area walls. When positioning
the #2 Front Panel into the vehicle, lower the panel evenly to prevent binding as the panel is positioned.
***Note: 1992-1995 YJ vehicles may not feature the outboard two #5.8 floor mounted seat brackets, but should
feature the center seat belt bracket and bolt. If desired, the two outer mounting holes may be drilled and bolted down
with hardware not included.
***Note: On 1992-1995 YJ vehicles featuring roll bar mounted rear seat belt retractors, installers may need to remove
the seat belt retractor along with the plastic cover in order to remove the two inboard #5.2 OEM roll bar bolts.
FIGURE 1
5. The #4.4 Rubber Edge Trim and #4.5 Plastic Edge Trim were installed at the factory, however if any pieces have
become dislodged during shipping, re-install these at this time. Install the #4.4 Long Rubber Edge Trim onto the rear
edge of the #1 Lid. Install the (2) #4.5 Plastic Edge Trim pieces onto the #1 Lid left and right side flanges, as
illustrated. (Figure 2)
FIGURE 2