Tuffy Security 238 - Manual

Tuffy Security Products, www.tuffyproducts.com , (970) 564-1762 Page 1 of 2 - 12/1/2009
INSTALLATION INSTRUCTIONS
Custom Security Lock Box, Part #238
Please read and fill out the enclosed warranty registration card to activate your warranty.
PARTS CHECKLIST
#238 Custom Security Lock Box #6 Tray (Not Included with all sizes) Rubber Seal
SHIPPING PACKAGE CHECKLIST
#9.3 (4) 5/16-18X1 ¼” Bolts #9.1 (8) 5/16-18 Nuts #9.2 (12) 5/16” Washers
TOOLS NEEDED
• Electric drill
• 3/8” Drill bit
• Marker or pencil
• Knife
• ½” Socket and ratchet
• ½” Wrench
• Silicone sealant (Recommended)
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
1. Install rubber seal on lid and check lock operation. (See Figure 1)
2. Place the Lock Box in the desired mounting location, ensuring that all necessary
accessories such as the vehicle jack, fuse panels, etc., will still be accessible.
3. Using a marker or pencil, mark (4) spots through the 3/8” mounting holes in the
bottom of the trunk.
WARNING!
Make sure that there is nothing under the vehicle that will be damaged by the
drill bit when drilling. IN MOST VEHICLES THERE IS A GAS TANK
UNDERNEATH THE REAR OF THE VEHICLE. THE GAS TANK MAY
HAVE TO BE LOWERED TO INSTALL THE MOUNTING BOLTS. PLEASE
CONSULT VEHICLE SERVICE MANUAL FOR INSTRUCTIONS ON
LOWERING THE GAS TANK.
4. Remove the Lock Box. Cut the carpet at the (4) marked holes. Using a 3/8” drill
bit, drill out the (4) marked spots in the floor.
5. It is recommended to use silicone sealant in any holes drilled in the vehicle to prevent rusting.
6. Fasten the Tuffy box to the vehicle using (4) #9.3 Bolts, (4) #9.1 Nuts and (8) #9.2 Washers as illustrated. (See Figure 2)