Tuffy Security 108 - Manual

Page 1 of 2 - 1/28/2008 – Rev122006
INSTALLATION INSTRUCTIONS
Ford Bronco Glove box 1966-1977 Part # 108
Please read and fill out the enclosed warranty registration card to activate your warranty.
Tools Needed
‰ Phillips head screwdriver
‰ 1/8” allen wrench
‰ ¼” Wrench
Shipping Package
(4) #6 Flat Washers (4)#4-40 Locknuts (5)10-32 x 1/2” Button Head Cap Screws
Included Parts
Tuffy Part#108 Bronco Glove box 108-Mounting Bracket and 108-Cover
Mounting Directions
1. Remove the factory glove box including all hinges, support straps, and lock catches.
2. In some 1971-1977 Broncos there will be a metal plate on the inside of the original glove box that
will need to be removed. The plate will be remounted on the inside of the Tuffy glove box for
fastening the fuse panel. If you do not need the cut out in the left side of the glove box, use the
provided cover and the nuts and washers to secure the cover to the glove box. See Figure 1.
3. Remove the paper off the double sided tape on the mounting bracket and tape the mounting
bracket to the dash as shown in Figure 2. Be sure that the holes in the dash line up with the nuts
in the mounting bracket.