Tuffy Security 289 - Manual

Page 1 of 2 - 1/5/2012 – Rev122006
INSTALLATION INSTRUCTIONS
Conceal Carry Valuables Tote #289-101 & #289-089
Please read and fill out the enclosed warranty registration card to activate your warranty.
Attention:
Use code “ 12345 ” to unlock part #289-089 with the pushbutton combo lock. Instructions to change the code are below.
PARTS CHECKLIST
Lockbox Enclosure
#10.7 (4) ¼-20 x 1” Screws #10.8 (8) ¼” Washers #10.9 (4) ¼-20 Nuts
TOOLS NEEDED

Electric drill

5/16” Drill bit

Marker or pencil

7/16” Socket and ratchet or wrench

5/32” Allen wrench

Silicone sealant (Recommended)

T-15 Torx (Only required for changing the combo code on Part# 289-089)
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
Mounting instructions
1. Identify the location where the box will be mounted and verify the following:
1.1. There should be sufficient clearance in front of the enclosure for the box to slide in and out.
1.2. Make sure the surface is structurally adequate for mounting.
1.3. The box can be mounted through the holes in the bottom or back and can also be mounted inverted.
1.4. Ensure there is nothing on the opposite side of the mounting surface that can be damaged by the drill bit when drilling.
1.5. Check that there is sufficient room for tool access on the underside when fastening the mounting hardware.
2. Using a marker or pencil, mark (4) spots through the mounting holes in the enclosure.
WARNING! Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.
3. Fasten the enclosure using the illustrated hardware included. Use silicone in drilled holes to prevent rusting. (See Figure 1)
Figure 1