Tuffy Security 248 - Manual

Page 1 of 3 - 5/17/2010 – Rev122006
INSTALLATION INSTRUCTIONS
TJ & LJ Conceal Carry Security Drawer #248
(Fits vehicles where the driver’s side seat does not flip all the way up. These vehicles
DO NOT HAVE the CAFS code on the Jeep build sheet = “Easy Access Driver Tip &
Slide Seat” or “Easy Access Driver Seat”)
Please read and fill out the enclosed warranty registration card to activate your warranty.
PARTS CHECKLIST
Enclosure Drawer #5 Front mount #4 Rear mount
#8.13 - (4) 10-32 x ½” Screw #8.15 - (4) #10 Nut #8.14 - (4) #10 Washer
TOOLS NEEDED
• ½” Socket and Ratchet
• T-50 Torx socket or wrench
• 1/8” Allen wrench
• 3/8”
Wrench
• Flat head screwdriver
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
Warning! Do not operate the vehicle without the drawer locked shut. If left unlocked
normal vehicle movements while driving could cause the drawer to open creating an
unsafe situation. As a result from maximizing the drawer storage height in TJs 1997-2002
the seat (forward & aft) re-position lever is very close to the top of the enclosure and can
create a pinch point so use caution in adjusting the seat position.
Note: The original seat mounting brackets shown in the illustrations are representative of TJs
2003-2006, earlier models will look different. To remove the drawer from the enclosure, pull the
drawer out as far as it can go then locate the small black plastic stops visible on the ball bearing
drawer slides. One of the black stops will need to be deactivated by pressing down and the other
one pulled up. Be careful not to break plastic stops. While deactivating the stops push the center
slide section back into the drawer enclosure off of the front slide section attached to the drawer
until they are separated. To reinstall, line up the slide sections and push the drawer in gently, do
not force it or it can be damaged.