Tuffy Security 251 - Manual (Page 2)

Page 2 of 2 - 9/8/2010 – Rev122006
Note: On some vehicles the cable connected to the bottom of the driver’s seat may need to be rerouted. To
do this, unplug the cable and in some vehicles pop the cable clamp out of the hole in the vehicle floor using
a flat head screwdriver then reroute the cable and plug it back in. Carefully check that the cable will not
catch, be pinched or stretched and damaged when the seat is maneuvered all the way forward, back and
when flipped up forward.
5. Insert the (2) original front seat front mounting bolts #8.10 and tighten them all the way. Reinstall the
rear mounting bolts as well if they were removed previously. (See Figure 1)
6. For additional security install the #5 Bolt-blocker plate by inserting the front flange on the #5 plate so
it is sandwiched under the flange on the enclosure and the floor of the vehicle and maneuvering it
towards the rear of the vehicle until the holes line up. (See Figure 1)
7. Reinstall the one #7.2 screw, #7.3 washer and #7.4 nut securing the #5 Bolt-blocker plate to the
enclosure and the left slide as illustrated. The floating center slide will need to be positioned to allow
access to the #7.2 Allen head screw. (See Figure 1)
Figure 1
Call (970)564-1762 for Technical Support