Tuffy Security 103 - Manual (Page 2)

Page 2 of 5 - 6/4/2008 – Rev122006
Shipping Package (Continued)
(2)10-32 Lock Nuts
(4) 5/16” Lock Nuts (2) 1” Diaphragm Grommets
(2) 5/16” U-Bolts (2)5/16-18x3” Carriage Bolts Rubber Seal
TOOLS NEEDED
• 1/8” Allen Wrench
• 3/16” Allen Wrench (Wranglers Pre 2003 without full roll cage only)
• T-20 Torx Driver (Wranglers Pre 2001 only)
• Small Phillips Screw Driver
• 5mm Allen Wrench
• ¼”
Socket
• ½” Socket and Ratchet – Extensions and Swivels are helpful (Vehicles with Roll Cage only)
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
These instructions will guide you through the installation of your new overhead console in the following
vehicles:
• Stock Jeep Wranglers 2000 or earlier
• Stock Jeep Wranglers 2001-2002 (With Footman loop riveted to windshield)
• Stock Jeep Wranglers and Rubicons 2003+ (With Large Oval Roll bar Pad)
• Vehicles with a full roll cage and distance from front to rear bar between 28” to 36-1/2”
If your vehicle does not fall into one of these categories you may have to make modifications to mounting
brackets, and/or purchase additional hardware.