Tuffy Security 044 - Manual

Page 1 of 2 - 1/31/2014 – Rev122006
INSTALLATION INSTRUCTIONS
TJ Console Part #044
Please read and fill out the enclosed warranty registration card to activate your warranty.
Shipping Package
(2) 1/4 x ¾” Self Tapping Screws (2) 5/16-18 X 1 ¼” Bolts
(2) 5/16 Locknuts
(4) 5/16” Washers (4) 10-32x1/2 Screws
(2) 10-32 Nylock nuts
(2) #10 Washers Neoprene seal
Tools Needed
(1) ½” wrench or ratchet, socket, and extension
(1) ½” wrench
(1) 3/8” wrench or ratchet, socket, and extension
(1) 5/16” Wrench
3/8” drill bit
Electric drill
Silicone sealant (not necessary but recommended)
Installation
1. Please read all instructions before starting installation.
2. It is recommended to use silicone sealant on any mounting points to vehicle body to prevent future rust problems.
3. Removing one or both of the seats will make installation easier.
4. Apply the rubber seal to the underside of the lid. (SEE FIGURE 1)
5. If you do not have a factory console, remove the rubber emergency brake cover. Save these screws because you may reuse some
of them.
6. Attach the drink holder to the rear of the console using (2) 10-32 x ½” bolts, (2) 10-32 nylock nuts and (2) #10 washers.
Warning! Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.
7.
Drill out the two original mounting holes (HOLES 1 AND 2 IN FIGURE 2), located on the floor of the vehicle, to 3/8” diameter.
8. Install the Tuffy console by guiding the console over the emergency brake, Be careful not to tear the seats.
9. Insert the (2) ¼-20 x ¾” self tapping screws in the holes (HOLES 3 AND 4 IN FIGURE 3) on the passengers side of the console.