Tuffy Security 033 - Manual (Page 2)

Page - 2 - of 3 - 1/28/2008 – Rev122006
TOOLS NEEDED
• Electric
drill
• 3/8” Drill bit
• Marker or pencil
• Knife
• ½” Socket and ratchet
• ½”
Wrench
• 3/8”
Wrench
• 5/16”
Wrench
• Silicone
sealant (Recommended)
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
1. Install the rubber seal around the edge of the lid and check the lock operation (See Figure 1)
2. Attach the mounting bracket to the two ¼” holes on the bottom of the console through Holes #1 & #2
using (2) 10-32x1/2” Bolts, (2) 10-32 Locknuts, and (2) 3/16” Washers. (See Figure 2)
3. Attach the drink holder to either the front or the rear of the console using (2) 10-32x1/2” Bolts, (2)10-
32 Locknuts, and (2) 3/16” Washers. NOTE: If the drink holder will be mounted on the front there are
three different mounting heights to choose from. Additional drink holders may be purchased
separately from your local dealer or directly from Tuffy.
4. Place the console between the seats and mark the floor directly under the (3) 3/8” mounting Holes #3,
#4, & #5 in the bottom of the console. (Check to make sure that the shift lever will not interfere with
the lid operation.)
WARNING!
Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.
5. Remove the console, cut holes in the carpet where the marks are and drill a 3/8” hole in each spot. Use
touch up paint or silicone sealant in any drilled holes to prevent rusting.
IF YOU HAVE A DELUXE STEREO CONSOLE TUFFY PART NUMBERS 013, 017, 024, 033.
ATTENTION: Refer to your stereo owner’s manual for instructions on how to mount and wire your
stereo, the following are only general steps.
NOTE: If a stereo is to be mounted in the console an antenna extension wire will be required and is
available at most stereo equipment stores.
6. Run all required stereo and speaker wires to the console mounting location. Tuffy recommends
running wires in a protective wire loom and using rubber grommets when passing through any drilled
holes.
7. Fasten the stereo support strap included with your stereo to the back of the stereo. (If you do not have a
stereo support strap, some plumber strap may be substituted.)
8. Insert the stereo into the mounting bracket and fasten the other end of the stereo support strap to the
10-32 stud on the inside of the console using a 10-32 locknut and a #10 washer. See Figure 3.
9. Connect all wires to the stereo according to your stereo owner’s manual.