Fan troubleshooting chart – Twin City Axial Roof Ventilators and Tubeaxial Fans - IM-4000 User Manual

Page 6

Advertising
background image

6

Twin City IM-4000

Fan Troubleshooting Chart

PROBLEM

POSSIBLE CAUSES

FAN DOES NOT OPERATE

1. Wrong voltage.

2. Electricity turned off or not wired properly.

3. Tripped overload protector.

4. Blown fuses.

5. Loose pulleys.

6. Broken belts.

TOO LITTLE AIR

1. Wheel or propeller rotating in wrong direction.

2. Fan speed lower than design.

3. System is more restrictive (more static pressure) than expected.

4. Restricted fan inlet or outlet.

5. Inlet or outlet screens clogged.

6. Filters, if applicable, are dirty or clogged.

TOO MUCH AIR

1. Fan speed higher than design.

2. System is less restrictive (less static pressure) than expected.

3. Filters, if applicable, not in place.

EXCESSIVE HORSEPOWER

1. Wheel or propeller rotating in wrong direction.

2. Wheel or propeller rubbing on inlet venturi.

3. Fan speed higher than design.

4. Worn fan bearings.

EXCESSIVE NOISE

1. Wheel, propeller or sheaves loose.

2. Bearing or drive misalignment.

3. Accumulation of material on wheel or propeller.

4. Worn or corroded wheel or propeller.

5. Wheel or propeller out of balance.

6. Wheel or propeller hitting housing.

7. Bent shaft.

8. Bearings need lubrication.

9. Loose bearing bolts.

10. Loose or worn bearings.

11. Mismatched belts.

12. Belts too loose or too tight.

13. Belts oily or dirty.

14. Belts worn.

15. Loose fan mounting bolts.

16. Rattle of components in high velocity airstream.

17. Electrical noise.

18. Noise from high velocity air system.

19. Vibrating parts not isolated from building.

20. Vibrating ductwork.

EXCESSIVE VIBRATION

1. Wheel, propeller or sheaves loose on shaft.

2. Wheel or propeller out of balance.

3. Excessive buildup of dirt/dust on wheel or propeller.

4. Belts too loose or too tight.

5. Mismatched belts.

6. Bent shaft.

7. Bearing or drive misalignment.

8. Loose or worn bearings.

9. Fan mounting bolts loose.

10. Weak mounting base for fan.

11. Structures not cross-braced.

12. Curb not flat and level.

It is recommended that the users and installers of this shipment familiarize themselves with AMCA Publication #201,

“Fans and Systems” and publication #202, “Troubleshooting” which are published by the Air Movement and Control

Association (AMCA), 30 West University Drive, Arlington Heights, Illinois 60004. www.amca.org

Advertising