Twin Eagles TEGB42SD-B - Manual (Page 2)

1
ASSEMBLY INSTRUCTIONS –
T WIN E AGLES G RILL B ASE
1. Install casters w/ brakes (A) at the front of the
base and casters w/ out brakes (B) at the
rear and secure them with nuts (C).
2. Install shelf brackets (D) and (E) securing them
with screws (F) and side shelves.
3. Remove hex-head screws (G) and flat-
washer (H) using a
5
/
16
” wrench and place
the grill head into the cart.
4. Install the hex-head screws (G) with flat-washer
(H) back into place by initially hand tightening
them. Then use the 5/16” wrench to tighten the
screws completely.
5. Fasten the BBQ grill at the top-rear corners using
the Philip screws (I), reference picture no.2.
(A) Caster w/ brake
(Qty. 2)
(B) Caster (Qty. 2) (D) Shelf Bracket
(LEFT) (Qty. 2)
(E) Shelf Bracket
(RIGHT) (Qty. 2)
(G) Hex-head Philips
screw (pre-installed w/
washers) (Qty. 2)
(I) 10-32 x ½”
Phillips Screw
(Qty. 2)
(C) ¼”-20 hex nut (Qty. 16)
(F) Flat head screws (Qty. 8)
(H) Flat-washer
(pre-installed w/
hex-screw) (Qty. 2)
(D)
(E) (F)
( I )
( I )
(B)
(C)
(A)
(G)
(G)
(H)
(H)