Twin Eagles TEOR24-C - Manual (Page 6)

6
OPERATION, REFRIGERATOR
During initi al startup, or anyti me power is interrupted, there will
be an approximate 5 minute delay before the refrigerator starts.
During this period the controller will be assessing the tempera-
ture in the refrigerator and the display will appear errati c, this is
normal. The desired temperature set point can be programmed
during this start up period.
Starti ng your refrigerator
The refrigerator will begin start up when initi ally plugged in or
when power resumes aft er a power outage. At this ti me the re-
frigerator will take approximately 5 minutes to begin running as
noted above. If the refrigerator has been turned off during use,
“OFF” will appear on the display. To start the refrigerator from
the “OFF” positi on press and hold the ON/OFF butt on for three
seconds.
Set temperature
To set temperature set point, press and conti nue to hold “SET”
butt on. Aft er one second, set point will be displayed. While
holding “SET” butt on use the “WARMER” or “COLDER” butt on to
desired set point.
NOTE: Momentarily pressing & releasing “SET” butt on will access
informati on menu of control. Refer to appendix A for informati on
on this feature.
Refrigerator operati on
The available temperature range of the refrigerator is 33° to 45°
(1° to 7° C).
It may take up to 24 hours for your refrigerator to reach desired
temperature. This will depend on amount of contents loaded
and number of openings and closings of the door.
For best results allow refrigerator to “pull down” to desired set
point before loading. Once contents are loaded, allow at least 48
hours for temperature to stabilize before making any adjust-
ments to the set point.
Alarms
Your refrigerator control will monitor refrigerator functi on and
alert you with a series of audible and visual alarms.
• Door Ajar Alarm: If the door has been left
open for over fi ve (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will fl ash “do” and the LED light will be a steady
amber color. This will stop as soon as the door is closed.
• High and Low Temperature Alarm: If your
unit reaches an unacceptable temperature
outside of your set point, the alarm will
sound in one (1) second intervals. The
display panel will fl ash either “hi” or “Lo”
depending upon the conditi on and the LED light will be a steady
amber color. “hi” indicates that the temperature is 10° F (5.5°C)
above the set point and “Lo” indicates that the temperature is
10° F (5.5°C) below the set point. The alarm will remain acti ve
unti l the conditi on is corrected.
NOTE: During initi al appliance start-up, the high temperature
alarm may sound unti l the interior temperature reaches set
point.
• Temperature Sensor Fault: If the controller
detects that the temperature sensor is
not properly functi oning, a temperature
sensor alarm will sound. “E1” will fl ash on the display, and an
alarm will sound. Please call AGA MARVEL Customer Service or
your dealer if this error code is displayed.
• Condenser Needs Cleaning:
When the refrigerator has reached the
recommended amount of run ti me to neces-
sitate cleaning the air fl ow, “cL” will fl ash on the display as a
reminder. See the “Care and Cleaning” secti on for cleaning
instructi ons.
To clear the alarm:
1) Press and release the “SET butt on four ti mes.
“cnd” will be displayed on the screen.
2) While “cnd” is displayed, press and hold the “SET” but-
ton. The display will show the number of weeks the
refrigerator has been running.
3) While holding the “SET” butt on, press and release the
ON/OFF butt on. The number shown on the display will
reset to 0.
4) Release the “SET” key.
NOTE
Control
Figure 4
Door Switch
Alarm Mute
Press any key to mute the audible porti on of an alarm,.
NOTE-This acti on will only mute the alarm. If the conditi on that
caused the alarm conti nues, the alarm code will conti nue to fl ash
and will sound for 20 seconds every 60 minutes.
Turning Refrigerator Off
To turn refrigerator off , press and hold “ON/OFF” butt on for
three (3) seconds. “OFF” will appear on the display.