Craftsman 486.24326 - Manual (Page 7)

7
• Turn the lift handle as shown in figure 11 and attach it
to the side of the lift lever that is indicated. Use a 1/2"
x 1-1/4" hex bolt (C) and 1/2" nylock nut (M) in the
bottom hole and the clevis pin and small hairpin cotter
in the top hole.
Tighten the bolt and nut. See figure 11.
• Push the grip (V) onto the lift handle. See figure 11.
FIGURE 11
1/2" x 1-1/4"
HEX BOLT (C)
CLEVIS PIN (P)
1/2" NYLOCK
NUT (M)
GRIP (V)
SMALL HAIRPIN
COTTER
LIFT LEVER
FIGURE 12
• Perform the following steps in sequence to tighten the
bolts and nuts that remain loose. Refer to figure 12.
a. Turn the aerator upright, then lock the lift handle
into the transport position.
b. Tighten the eight bolts at the corners of the tray.
c. Tighten the two bolts which fasten the middle
brace to the bottom of the tray.
b
c
b
b
b