Vexilar V-410 - Manual

CHARGING INSTRUCTIONS
Please follow the instructions on this sheet when charging the
battery. Be sure to recharge after each use.
1. Attach the short pigtail (supplied) to the quick charge jack
plug coming out of the charging unit.
2. Plug the charger into a standard 110 volt wall outlet. If you’re
using a Vexilar Ultra Pack, be sure the Master Power Switch
is in the ON position. The GREEN light will come on. You do
not need to disconnect the flasher unit.
3. Connect the red clip to the positive battery terminal, or
charging post, and the black clip to the negative terminal,
or charging post. The GREEN light will change to RED,
indicating you are now charging.
4. Allow the battery to charge until the light turns back to
GREEN.
This charger is a fully automatic three-stage, 1 Amp, charger. It will recharge a completely
discharged battery in 8 hours or less. When the light turns GREEN, it indicates the charger
has switched to Maintenance Mode The battery voltage will be maintained at a safe level
indefinitely. You do not need to disconnect the charger until the battery’s next use.
TROUBLE SHOOTING
Charger Flashes Red: This means you have connected the battery terminals incorrectly Red is
positive, black is negative. Reverse the connections and look for a solid red light.
Battery Gets Hot: A battery that gets hot while charging has become “resistive”. Current passes
through it, but the battery will not charge. The battery must be replaced.
Battery recharges for a short time, even when full: Even if your battery is fully charged the light
should briefly go from red to green, when you first plug it in, this is normal.
Battery Will Not Charge: If you connect the battery and it stays green 100% of the time, your
battery may be completely dead and your charger does not even recognize it has been connected to
terminals. Battery should be replaced.
NOTICE
Battery failure due to excessive discharge (leaving it connected during storage periods) will
not be covered under warranty.
LIMITED WARRANTY
This Vexilar product is warranted against factory defects in material and workmanship for a period of 180 days
from the date of purchase. During the warranty period, Vexilar will repair or, at its option, replace at no cost
to you for labor, materials or return transportation provided the unit is returned, shipped prepaid to Vexilar Inc.,
6667 West Old Shakopee Road, Suite 101, Minneapolis, MN, 55438. In order to place the warranty in effect,
a valid purchase receipt clearly indicating date and place of purchase must accompany the returned product.
This warranty does not apply if the product has been damaged by accident or misused, or as a result of service
or modification by other than the factory. Except as otherwise expressly stated in this previous paragraph, the
company makes no representation or warranty of any kind, express or implied, as to merchantability, fitness for a
particular purpose, or any other matter with respect to this product. Company shall not be liable for, and purchaser
assumes responsibility for, all personal injury and property damage resulting from the handling, possession or use
of this product by purchaser or others who obtain it through the purchaser.