Water Factory Systems SQC 4 - Manual (Page 17)

How to Replace the RO Membrane Cartridge
1) Close the cold water supply shut off valve. Lift up on the
faucet handle to drain the tank. Wait five (5) minutes for
the filtration assembly to completely depressurize.
2) Make sure that there is some slack in the red SFC tubing
connected to the fitting at the bottom of the RO membrane
cartridge. Twist the cartridge 1/4 turn clockwise so that
the tubing connection is accessible. (See Fig. 8)
3) Remove the red SFC tubing by depressing the small gray
collet and pulling the tubing away from the fitting.
Note: It is advisable to check the end of the red SFC tubing
for nicks or scratches. If any are observed, cut off 1/4” from
the end of the tubing with a sharp razor knife.
4) Firmly pull the cartridge away from the head. (It may be
necessary to twist the cartridge slightly from side to side.)
5) Remove the new RO membrane cartridge from its sanitary
sealed wrapper. (Double check to see that it is the correct
replacement by comparing the labels.) Rinse it with tap
water and dry it off.
6) Remove the white plug from the fitting at the bottom of the
cartridge by pushing in the small gray collet and pulling out
the plug.
7) Remove the red plastic cap from the top of the cartridge.
8) Using tap water, food grade silicone lubricant or glycerin,
wet the O-ring seals to make cartridge insertion easier.
9) Reconnect the red SFC reject tubing by inserting it into the
fitting at the bottom of the new RO membrane cartridge as far
as it will go. Line up the cartridge ears, insert the cartridge
and push it into the head until it is fully seated. Twist the
cartridge 1/4 turn counterclockwise to lock it into place.
10) Open cold water supply valve and carefully check for
leaks. Carefully inspect the fitting at the bottom of the new
RO membrane cartridge.
11) Follow the sanitizing procedure for the storage tank and
the filtration assembly outlined below.
D. YEARLY MAINTENANCE SANITIZATION*
SANITIZING THE RO APPLIANCE
To assure the highest quality water from your RO Drinking
Water Appliance, it is important to routinely sanitize both the
storage tank and the filtration assembly.
IMPORTANT: These procedures are only intended to be
part of a routine maintenance program only and are not
designed to sanitize systems that have become highly
contaminated from misuse.
When to Sanitize the Storage Tank
• Upon start-up as described in the beginning of this manual.
• After any servicing or routine maintenance that involves
replacing the RO membrane cartridge, the postfilter(s), ser-
vicing the storage tank, or replacing the RO faucet.
When to Sanitize the Filtration Assembly
• After any servicing or routine maintenance that involves
replacing the RO membrane cartridge, the postfilter(s), ser-
vicing the storage tank, or replacing the RO faucet.
• After any extended period of non-use (over 30 days) unless
the cartridges are stored inside a sealed plastic bag in the
refrigerator.
Remove the red SFC tubing from
the fitting before completely
removing the RO membrane module
ON
OFF
Fig. 8
14
* Initial sanitization to be performed using instructions on page 6.