Cobra Electronics COBRA MARINE MR HH475 - Manual (Page 15)

24 English
Bluetooth ® Mode Pairing
and Programming
Operating Your Radio Operating Your Radio
25 Nothing Comes Close to a Cobra ®
Bluetooth ® Mode Pairing
and Programming
4. You will then see a confirmation of successful
pairing or a notice to try again if pairing did
not occur. The LCD will briefly display the word
“PairEd.”
NOTE
This process only needs to be completed for first
time operation. From then on, as long as your mobile
phone is within 30 feet (10 meters) of the radio, the
two units will “Pair” automatically. A “P” will now
be displayed if you press the Bluetooth button and
enter the Bluetooth Standby mode.
Bluetooth Pairing
Bluetooth Mode Programming
•
The default settings for how your radio answers and conducts Bluetooth mobile
phone calls can be adjusted.
VOX On or Off
The
VOX function converts the radio microphone’s pickup of
your voice from being controlled by the PTT button to being
activated by your voice. When
VOX is On, the PTT button
does not need to be pressed to transmit your voice, and
you can just speak into the microphone.
When VOX is Off, you need to press the PTT button while
speaking.
To Change Between VOX On and Off:
1. From the Bluetooth Standby mode, press and hold
Call/Enter/Setup button to access the Setup menu.
VOX On/Off will be the first menu item to appear.
2. Press the Channel Up and Channel Down buttons.
The display will show the selection of either ON or OFF.
3. Press the Call/Enter/Setup button to confirm
your selection and move to the next Setup
mode programming.
VOX
Call Tone Alert
If Call Tone Alert is set to On, the radio will “ring” with one
of your Cobra selected tones when you receive a call on your
mobile phone. If Call Tone Alert is set to Off, the radio will
ring with the default ring tone.
To Set Call Tone On or Off:
1. Display will show Call Tone icon and ON or OFF flashing.
VOX On/Off will be the first menu item to appear.
2. Press Channel UP/Down button to select ON or OFF.
3. Press the Call/Enter/Setup button to save this entry
and move to the next Setup mode programming.
The Call Tone icon will show in the Standby mode
when set to ON.
Call Tone Select (Ring Tones)
This setting controls what ring tones is used to alert for
incoming calls on your mobile phone. Ten different ring
tones are available from which to choose.
To Set Call Tone:
1. From the previous press of the Call/Enter/Setup button,
the LCD will display the letter “C” and the current Call Tone
number (01 through 10).
2. Press the Channel Up/Down button to select a different
Call Tone. An example of each call tone will sound for
1.5 seconds.
3. Press Call/Enter/Setup button to save this entry and
move to the next Setup mode programming.
Call Tone Alert
Call Tone Select
Bluetooth Standby Mode