Replacing the filter cartridge – WaterChef C7000 User Manual

Page 7

Advertising
background image

www.waterchef.com

The most important part of maintaining your WaterChef Filtration System is replacing the

Filter Cartridge (and Battery) on a regular service interval. To insure your System continues to

perform as stated in the Performance Data Sheet, the Filter Cartridge should be replaced

upon the first occurrence of the following:
- Annually
- The flow rate diminishes
- You notice a taste or odor recurrence
- The rated capacity of the Filter Cartridge has been reached
- The Intelligent Monitor

begins flashing RED

5

REPLACING THE FILTER CARTRIDGE

1. Remove the Lid Assembly by turning counterclockwise

until it separates from the Filter Housing. As you

remove the Lid Assembly, the Filter Cartridge will

remain attached to the Lid Assembly.

(fig. K)

2. Hold the Lid Assembly and rotate the Filter Cartridge

counterclockwise to remove. Discard the used Cartridge

with your regular refuse.

(fig. L)

3. Wash the inside of Filter Housing and Lid Assembly

with warm water, a mild dish washing detergent and

a clean cloth.

4. Remove the plastic sanitary wrap from your new Filter

Cartridge. Thread the new Cartridge clockwise onto

the threaded post on the Lid Assembly until you

feel resistance. Make an additional quarter turn.

Do NOT over-tighten.

(fig. M)

(continued on next page)

Rubber gloves should be worn to avoid direct contact with filtered
contaminants.

RECOMMENDATION

Do NOT use abrasive pads or other abrasive materials to clean
Filtration System.

CAUTION

Be sure to use only genuine WaterChef

®

CR70 Filter Cartridges with this System. Only WaterChef Filter Cartridges

have been tested and certified by NSF International to insure the performance represented in the Performance
Data Sheet.

IMPORTANT

K

L

M

Advertising