Wiko OZZY - Manual (Page 18)

~ Charging the Battery
Your phone is powered by a rechargeable battery.
The status light changes colour to indicate the charging
level of the phone. Connect the charger to a power outlet
and the micro UsB connector to the phone’s UsB port.
For more information, refer to the Safety Information
section.
~ Installing the Memory Card
Your phone takes a MicrosD memory card of up to 32GB.
To install a memory card, turn the phone off then remove
the back cover and take the battery out. Now insert the
memory card in the slot.
~ Turning the Phone On and Off
To turn the phone on, press and hold the ON/OFF button.
If your sIM card is locked, you must enter the correct PIN
code to unblock the sIM card when the phone is powered
up. Your PIN is supplied by your operator; if you did not
receive it or have lost it, please contact them.
When the PIN is entered incorrectly three times, the mobile
phone is blocked and has to be unblocked using your PUk
(this is supplied with the sIM card; if this is not the case,
you should contact your phone operator).
To turn the phone off, press and hold the ON/OFF button
until the menu opens, then press on switch Off. Now press
Ok to confirm.
The phone vibrates when it is shut down completely.