Celestron Advanced Series C6-R User Manual

Page 10

Advertising
background image

10

place. As mentioned above, there are two R.A. shafts, one on either side of the mount. It makes no difference which
shaft you use since both work the same. Use whichever one you find more convenient. If, after a few observing
sessions, you find the R.A. slow motion knob is more accessible from the other side, pull firmly to remove the knob,
then install it on the opposite side.

5.

The DEC slow motion knob attaches in the same manner as the R.A. knob. The shaft that the DEC slow motion

knob fits over is toward the top of the mount, just below the telescope mounting platform. Once again, you have two
shafts to choose from. Use the shaft that is pointing toward the ground. This makes it easy to reach while looking
through the telescope, something which is quite important when you are observing.

A

A

t

t

t

t

a

a

c

c

h

h

i

i

n

n

g

g

t

t

h

h

e

e

T

T

e

e

l

l

e

e

s

s

c

c

o

o

p

p

e

e

T

T

u

u

b

b

e

e

t

t

o

o

t

t

h

h

e

e

M

M

o

o

u

u

n

n

t

t

The telescope attaches to the mount via a dovetail slide bar mounting bracket which is mounted along the

bottom of the telescope tube. Before you attach the optical tube,
make sure that the declination and right ascension clutch

knobs are tight. This will ensure that the mount does not move

suddenly while attaching the telescope. To mount the telescope

tube:

In order for the GT computerized mount to function properly,
before installing the optical tube, the mounting platform must be
positioned so that the Declination Index Marks are aligned (see Fig
2-8).


1 Locate the mounting bracket from the box containing the equatorial
mount head.

2 Attach the mounting bracket to the tube rings so that the tapered (narrow)
end is against the bottom of the tube rings.

3 Loosen the hand knob on the side of the CG-5
mount.

4 Slide the mounting bracket that is attached to
the bottom of the tube rings into the recess on the
top of the mounting platform (see figure 2-9).


5 Tighten the telescope mounting screw on the
CG-5 mount to hold the telescope in place.

6 Hand tighten the mounting platform safety
screw until the tip touches the side of the mounting
bracket.

NOTE: Never loosen any of the knobs on the
telescope tube or mount other than the R.A. and
DEC clutch knobs.






Advanced

GT Users!

Declination
Index Marks

Figure 2-8

Figure 2-9

Advertising
This manual is related to the following products: