CTX p772L - Manual (Page 8)

♦♦♦
5
English
INTRODUCTION
Recommended Use of the Monitor
• Power
– Use the type of power indicated on the marking label.
• Plugs
– Do not remove any of the prongs of the monitor's three-pronged power plug.
– Disconnect the power plug from the AC outlet if you are not going to use it for an
indefinite period of time.
• Power cords
– Use the proper power cord with correct attachment plug type. If the power source
is 120 VC, use a power cord that has UL and CSA approvals. If the power source
is a 240 VAC supply, use the tandem (T blade) type attachment plug with ground
conductor power cord that meets the respective European country's safety
regulations, such as VDE for Germany.
– We recommend using the power cord supplied with the product. However, if
another type of power cord is required power cord H05VV-F or VW-1, 18AWG x
3G should be used.
– Do not overload wall outlets or power cords. Ensure that the total of all units
plugged into the wall outlet does not exceed 7 amperes.
– Ensure that the total ampere ratings on all units plugged into the extension cord is
not above the cord's rating.
– If the power supply cord which came with your monitor is to be connected to the
PC instead of the wall outlet, this equipment should be used with UL/TUV approved
computers with receptacle rated 100~240V AC, 50/60Hz, 1.1A (minimum).
– Do not allow anything to rest on the power cord. Do not locate this product
where persons will walk on the cord.
• Environment
– Place the monitor on a flat level surface.
– Place the monitor in a well-ventilated place.
– Keep the monitor away from:
rain or water
overly hot, cold or humid places
sunlight
dusty surroundings
equipment that generates strong magnetic fields