Wilson Audio WATCH Dog Subwoofer Series-2 - Manual (Page 54)

54
“Standby.”
6. Ensure that all system cabling is correct and secure. At this point in the set
up process, the input switches should be configred properly, according to
instructions elsewhere in this manual. It is now time to optimize Level, Phase
and EQ settings.
7. If you are filtering the bass to your L & R speakers, select “HP In,” and set
the high pass frequency according to the acoustical measurements you
have taken. Start with HP 12 dB per octave slope.
8. Initially select the low pass frequency 10 % lower than the setting for the
high pass frequency.
9. Select “LP In” and LP 18-dB / octave slope.
10.Initially set the Phase control at 90°.
11.Select “EQ Out” at this point in the calibration.
12.The output level control should be in the “Min” position.
13.Turn on the program source components and pre-amplification.
14. After two minutes of stabilization time, turn on your WATCH Dog subwoofer.
15. After two additional minutes of stabilization time, turn on your L & R chan-
nel power amplifiers.