Step 4 step 5 – Winco 2-Wheel Dolly Kit Assembly Instructions (2013) User Manual
Page 4
4
3038-02
6204-007I
STEP 4
STEP 5
Place axle bracket (ref. 4) under the cradle (engine end) and attach using bolts
(ref. 6), nuts (ref. 0) and lock washers (ref. ). It is centered on the cradle.
Remove and discard axle protectors (ref. 6). Place spacer (ref. 8), washer (ref.
3), wheel (ref. ), washer (ref. 3) on the axle. Then tab the hubcap (ref. 2) on
the axle. Then slide assembly through axle bracket. (ref. 4) Place other spacer,
washer, wheel, washer and hubcap on axle.
Remove the blocks under the gen-set. Tap the other hubcap (ref. 2) onto the
axle. NOTE: Do not tap too hard as you may dent the hubcaps.
•
•
•
Winco Inc.
Service Dept.
507-357-683
Attach leg support and handle assembly to the cradle using bolts (ref. 8), lock
washers (ref. ) and nuts (ref. 0). Repeat for other leg support and handle as-
sembly.
•
Engine End