Crimestopper Security Products EZ-55DP - Manual (Page 12)

12
2-VEHICLE OPERATION
A single remote can control two different vehicles EZEE START systems installed. However, both systems must be
the same type. EZ-45DP II/55DP II are only compatible with each other.
Programming:
You must first Programming your remote for 2
nd
vehicle operation:
(2
nd
Vehicle Programming and Operation instruction):
In step #4 of transmitter programming (see page 11) press and hold middle button #5 for 2 sec., then press the lock
button, parking light will flash indicating the remote is programming.
Operation:
Press vehicle #2 button (middle button) for 2 sec. and within 3 seconds press any of the 4 function buttons on your
remote. You can keep pressing function buttons to control car #2 as long as it is within the 3-second window. After 3
seconds have elapsed, the remote will revert back to Car #1 operation.
TROUBLESHOOTING: “BEFORE YOU CALL” SECTION
UNIT WILL NOT ATTEMPT A START (KEYLESS ENTRY STILL FUNCTIONS NORMALLY):
The unit is in Valet mode. Turn Ignition ON, press and hold valet/programming button for 6 seconds then turn
key off. Unit is now out of valet mode and should perform a remote start. If optional LED indicator is installed,
then it will be on solid when in Valet and OFF when out of Valet.
UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START:
The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Blue wire grounded). This is
a safety feature of the unit. Check installation for faults and make sure hood is closed and latched and brake
wire is not active. Make sure hood is in good condition and is depressed when hood is closed.