Winco 2-Wire Conversion Instructions PSS15B User Manual
Winco Equipment
INSTALLATION INSTRUCTIONS
FOR 2-WIRE AUTO START CONTROL
The following instructions are provide to convert the PSS15B4W from a
special 4-wire start system to a standard 2-Wire Auto Start system.
Items required:
WINCO Conversion Kit # 16448-003 Auto Start
T25 Torx Screwdriver
7/16” End Wrench or Socket & Driver
Side Cutter
PROCEDURE
1.
Move the toggle switch to the off and stop position.
2.
Remove the generator end
panel opposite the air discharge.
3.
Remove the battery negative
cable if the battery is installed.
4.
Remove the cover over the
customer connection box.
5.
Remove both black wiring
cables plugged in the current 4-
wire engine control. These connec-
tors have threaded retaining collars.
Turn the collars counterclockwise to
release and pull to remove the con-
nectors.
6.
Remove the two sheet metal
screws (T-25 Screws) holding the 4-
wire engine control in place. Remove
the engine control and set aside.
7.
Reuse the two sheet metal
screws to install the new 2-wire
engine control. Be sure the toggle
switch is in the OFF (center) position.