Conair INFINITI 224 - Manual (Page 3)

KNOw EVERYTHING ABOuT THE INFINITI HAIR DESIGNER PRO BY CONAIR ™
KNOw EVERYTHING ABOuT THE INFINITI HAIR DESIGNER PRO BY CONAIR ™ KNOw EVERYTHING ABOuT THE INFINITI HAIR DESIGNER PRO BY CONAIR ™
KNOw EVERYTHING ABOuT THE INFINITI HAIR DESIGNER PRO BY CONAIR ™
9. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen
is being administered.
10. Do not use an extension cord to operate dryer.
11. Do not direct hot air toward eyes or other heat-sensitive areas.
12. Attachments may be hot during use. Allow them to cool before handling.
13. Do not place appliance on any surface while it is operating.
14. While using the appliance, keep your hair out of it. Keep your hair away from the air inlets.
15. Do not use with voltage converter.
SAVE THESE INSTRuCTIONS
OPERATING INSTRuCTIONS
This appliance is intended for household use only. Use on Alternating Current (60 hertz) only. Standard Dryers are
designed to operate at 110 to 125 volts A.C.
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to defeat this safety feature.
IMPORTANT –
1875 wATT OPERATING GuIDE
Use of this dryer on the same circuit or fuse with other electrical products or appliances
may trip a 15 amp circuit breaker or blow a 15 amp fuse. NEVER replace the fuse with
one rated higher than the capacity of the circuit. Doing so could result in an
electrical fire.
CHECK ALCI SAFETY FEATuRE EVERY TIME YOu uSE APPLIANCE.
This appliance is equipped with an Appliance Leakage Circuit Interrupter (ALCI), a safety
feature that renders it inoperable under some abnormal conditions, such as immersion
in water. To make sure the ALCI is functioning properly, perform the following test.
The purpose of this test is to allow you to make sure the water sensing system (ALCI)
is working.
Reset
Test
Reset
Test