Prescrizioni di sicurezza, Safety requirements – Winco ECO3 User Manual

Page 12

Advertising
background image

Nelle vicinanze della macchina non ci devo-
no essere persone con indumenti svolaz-
zanti tipo: sciarpe, fular, bracciali, etc e
qualsiasi indumento deve essere chiuso con
elastici alle estremita’.

I generatori non devono mai e per nessuna
ragione funzionare con le seguenti protezioni
aperte:
- copertura frontale.
- protezioni delle ventole.

A richiesta puo’ essere montato un tipo di
regolatore corredato di segnalazioni a led,
che sono:
Verde - funzionamento regolare
Giallo - intervento protezione
sovraccarico
Rosso - intervento
protezione bassa velocita’

I generatori sono rumorosi; anche se il livello
acustico è sicuramente inferiore a quello del
motore primario, devono essere installati in
ambienti isolati (stanza, sala macchine, etc.)
e chi vi accede deve munirsi di cuffie
antirumore.

I generatori sviluppano calore anche elevato
in funzione della potenza generata.
Pertanto non toccare il generatore se non
con guanti antiscottatura e attendere, una
volta spento, che esso raggiunga la tempe-
ratura ambiente.

Anche se la macchina e’ protetta in tutte le
sue parti evitare di sostare nelle sue vici-
nanze.

Per nessuna ragione appoggiarsi o sedersi
sul generatore.

Non togliere per nessuna ragione le eti-
chette, anzi richiederne la sostituzione in caso
di necessita’.

PERICOLO DI CORTO CIRCUITO
Il generatore e’ costruito con grado di pro-
tezione IP23; pertanto e’ fatto divieto di
spruzzare o di mettere contenitori di liquidi
sopra le parti elettriche.

In caso di sostituzione di pezzi di ricambio
richiedere esclusivamente ricambi originali.

Per la sostituzione di parti usurate compor-
tarsi rigorosamente come descritto al capi-
tolo manutenzione; queste manutenzioni
devono essere eseguite da tecnici adegua-
tamente qualificati.

PRESCRIZIONI DI
SICUREZZA

12

SAFETY
REQUIREMENTS

No person must wear fluttering clothes (such
as scarves, etc.) near the machine and any
garment must be fastened with elastic bands
at its ends.

The generators must never and for no reason
run whith following guards removed:
- terminals cover
- fan guards.

If required, the generator can be equipped
with a regulator with led display, as follows:
Green - regular operation
Yellow - overload protection activated
Red - low speed protection activated

The generators are noisy; even if the sound
level is certainly lower than that of the prime
motor, they must be installed in soundproof
rooms (room, engine room, etc.) where it is
necessary to wear antinoise car protectors.

The generators produce heat proportional to
the output.
Therefore, do not touch the generator if you
do not wear antiscorch gloves and, after
switching it off, do not touch it until it has
cooled down.

Even if all the machine components are
protected, keep away from the machine.

Do not lean or sit on the generator for
whatever reason.

Do not remove the labels for whatever
reason; on the contrary, if necessary, replace
them.

DANGER OF SHORT CIRCUIT
The degree of protection of the generator is
IP23; short circuits may occur if liquids are spilt
onto areas containing electrical parts.

In case of replacement of spare parts, use
original spare parts only.

For the replacement of worn parts, carefully
follow the maintenance instruction; these
operations must be carried out by skilled
technicians.

ECO3-N Manual - February 2007 revision 12

Advertising