Winco W165PTOT - Manual (Page 6)

Page 4 60706-160 REV 3 3117-30
D. The generator mounting area of the trailer bed should be
flat. All four generator mounting pads must rest firmly on the
trailer bed. Install shims if necessary to even out the bed
under the mounting pads, then bolt the generator firmly in
place.
ELECTRICAL CONNECTIONS
CAUTION:
Only qualified electricians should install electrical wiring.
Wiring must conform to all applicable national, state, and local
codes. (Reference: National Fire Protection Association
Manual No. 70, National Electrical Code.)
DANGER: PERSONAL INJURY
IF THE GENERATOR IS TO BE USED AS A STANDBY
POWER SOURCE, A SPECIAL DISCONNECT SWITCH
MUST BE INSTALLED TO SEPARATE THE GENERATOR
AND THE COMMERCIAL POWER LINES. THE
DISCONNECT MUST ISOLATE THE GENERATOR FROM
THE COMMERCIAL POWER LINES AND THE LOAD WHEN
Typical Connection Methods for Generator Power Service Figure 5